ISTech Support Forum

ISTech Support Forum
http://www.istechforum.com/YaBB.pl
Evo-ERP and DBA Classic >> Problem Reports - Repeatable >> SM-J-C Issue
http://www.istechforum.com/YaBB.pl?num=1257529441

Message started by gtladmin on 11/06/09 at 10:44:01

Title: SM-J-C Issue
Post by gtladmin on 11/06/09 at 10:44:01

We noticed just now when running SM-J-C in our test company that when you did a method A on a specific part, the program did only run for that part. However, when we used method B, even though we specified a specific part, it ran for all parts up to the specified part and it stopped at the part just after the part we specified. We tried this twice and both times the results were the same for method B - it ran for all parts up to and including the specified part and stopped at the part just after the one we specified.

Interesting.....

Val

Title: Re: SM-J-C Issue
Post by Vman on 11/06/09 at 14:19:10

Been that way for as long as I can remember. It would be nice if only ran the range you enter to save processing time.

Title: Re: SM-J-C Issue
Post by gtladmin on 11/09/09 at 07:51:33

Thanks for letting me know - I don't run it, Nancy does. She swears it's never done that before. But maybe she hasn't run it this way before.
I dunno.

Val