ISTech Support Forum

ISTech Support Forum
http://www.istechforum.com/YaBB.pl
Evo-ERP and DBA Classic >> Problem Reports - Repeatable >> enter venders AP-A
http://www.istechforum.com/YaBB.pl?num=1315338865

Message started by ddlong on 09/06/11 at 12:54:25

Title: enter venders AP-A
Post by ddlong on 09/06/11 at 12:54:25

When entering a vender using T7APA.RWN, not sure what is going on, but after we enter in all of the vender data, it loops to the first page again then when we click on "save" it just sits there. If you enter again, it says that the vender code already exists and gives you a box to type in another code. If you choose cancel, it changes the vender code to blank and when you go back in, there is a file with a blank vender code as well as one with the vender code, then to make matters worse, any part number that doesn't have a vender designated will now pull in the vender name from that blank code because its treating the blank as it would a vender code.

I can switch our program back to bkapa.run, but it looks as though it just needs to clear the screen after saving, instead of looping to the header screen.

Don't know if this has been reported as a glitch.

Darla Long
EVO 5/17/11 SP1

Title: Re: enter venders AP-A
Post by ddlong on 09/09/11 at 08:40:47

Lynn sent me an updated file and all is working as it should now.